Colorful plastic clothespins clipped onto a green clothesline against a pale sky.

9 Ways to Make Laundry Day Cheaper and Greener

The average American family washes about 300 loads a year. Small changes in temperature, load size and drying habits trim energy, water and detergent costs without buying a new machine.

In brief

  • Heating water accounts for up to 90 percent of the energy a wash cycle uses, so washing cold is the biggest saving available.
  • One full load takes less energy than two small ones, but an overpacked drum slows both washing and drying.
  • Moisture sensors save energy and reduce wear, though testing shows many dryers still over-dry; pull quick-drying items out early.
  • Cleaning the lint filter after every load keeps airflow strong so the dryer finishes the same job sooner.
  • Heat pump dryers use around 70 percent less energy than conventional models, and federal rebates offer up to $840 where state programs cover them.

Laundry looks like a small line item, but it runs through every week of the year. The average American family washes about 300 loads annually, and roughly 80 percent of US homes have a clothes dryer, so small changes to the routine multiply quickly. None of the ideas below require buying a new machine. They cover wash temperature, load size, detergent and drying habits.

1. Know Where Laundry Costs Come From

A washing machine spends energy in two places: turning the drum and heating water. Heating water accounts for up to 90 percent of the energy a wash cycle uses, which is why temperature matters more than almost any other setting. The dryer is the other major cost. Its whole job is heating air and pushing it through wet fabric, and ENERGY STAR estimates that if every dryer sold in the United States were certified, Americans would save more than $1.5 billion a year in utility costs. The machine itself matters over the long run too. ENERGY STAR certified washers use about 20 percent less energy and about 30 percent less water than regular models and can save about $530 in energy costs over the washer’s lifetime. But every idea below works with the machine you already own.

2. Wash Cold for Most Loads

Switching from hot to cold water can cut laundry energy use by up to 50 percent, and most everyday stains and dirt come out in cold water with the right detergent. Many detergents are formulated with surfactants and enzymes that work in water as cold as 60°F, so check the label for cold-water performance. Cold water is also gentler on fabric. It causes less color bleeding, fading and wrinkling than hot water, which helps clothes hold up longer.

Cold water does have limits. Warm water does a better job on stubborn odors, and heavily soiled items may need extra help. One related setting worth checking sits outside the laundry room: lowering your water heater’s temperature cuts the cost of every hot-water tap in the house, laundry included.

Try this: For smelly loads washed cold, soak the items first and pre-rinse with vinegar, which helps break down the bacteria that cause odors.

3. Run Full Loads, But Leave Room to Tumble

It takes less energy to run one big load than two smaller ones, so waiting for a full basket pays off. The exception is an overpacked machine. A dryer load that is too large takes longer to dry because hot air cannot circulate, and a stuffed washer will not clean evenly. Mix small and large items in each load so clothes can move freely.

Tiny loads waste resources in the other direction. Drying a single towel for 30 minutes costs about as much as drying a full load for the same time. If you only have a few items to wash, use the reduced load or small load setting, which adjusts water and energy use to match.

4. Measure Detergent and Skip the Extras

The dose printed on a detergent label is matched to load size and soil level, so measure instead of pouring by eye. Overshooting wastes detergent and the money spent on it. Treat stains before the wash with a stain remover or a small amount of detergent applied directly to the spot, since pre-treating reduces the work the cycle has to do. Add-ons such as bleach and fabric softener are optional steps rather than standard ones, so reach for them only when a load genuinely needs them.

5. Let the Moisture Sensor End the Cycle

If your dryer has an automatic dry setting, use it instead of a timed cycle. Sensors that detect when clothes are dry shut the machine off early, which saves energy and prevents some of the wear that over-drying causes. There is a caveat. Testing of automatic termination cycles has found that many dryers still over-dry, wasting as much as 62 percent of the cycle’s energy in some cases. So trust the sensor but check the drum: pull lightweight synthetics and other quick-drying items out partway through instead of letting everything run until the slowest piece is done.

If your dryer is nearing the end of its life, heat pump dryers use around 70 percent less energy than conventional models. Federal rebate programs offer up to $840 for heat pump dryers, though each state, territory and Tribe manages eligibility, so check what your state’s program covers.

6. Air-Dry the Items That Benefit Most

A clothesline or drying rack costs little and uses no energy at all. Sweaters, jeans and anything with stretch or elastic hold up better when they skip the heat, since air drying avoids the wear and tear a hot drum adds. Even moving part of each load to a rack cuts dryer time. The trade-offs are space and patience. Air drying takes hours instead of an hour, and in humid weather or a small apartment a rack needs a spot with decent airflow.

7. Clean the Lint Filter and Check the Vent

Clean the lint filter after every load. Lint blocks airflow, and a clogged filter makes the dryer run longer to do the same job. After every few loads or so, walk outside and check that the vent is clean and that the flap closes properly when the dryer is off. If your dryer has started needing two cycles where one used to be enough, the vent is a sensible first thing to check.

8. Think Before You Switch to Sheets and Concentrates

Detergent now comes as liquid, powder, pods, sheets and concentrates, and the option that looks greenest is not always the one that is. Sheets and concentrates cut the water weight shipped in a bottle, but eco claims on cleaning products vary widely in what they actually guarantee. Vague terms deserve skepticism, and our guide to spotting greenwashing explains how to read them. For a clearer signal, look for third-party certification such as EPA’s Safer Choice label, which we break down in our piece on safer cleaning products. Whichever format you pick, compare the price per load rather than the price per package, since recommended doses differ by format, and follow the dosing instructions so you are not paying for detergent that goes down the drain.

9. Stack the Small Habits Over a Year

None of these changes is dramatic on its own, which is exactly why they get skipped. But 300 loads a year turns each small saving into a recurring one. A workable starter set:

  • Wash cold by default and warm only when a load genuinely needs it.
  • Wait for full loads and use the small-load setting when you cannot.
  • Pre-treat stains so cycles can stay short and cool.
  • Use the moisture sensor and pull quick-drying items early.
  • Clean the lint filter every load and check the vent now and then.
  • Air-dry whatever will tolerate it.

Cooler washing and gentler drying also slow the wear on fabric, which stretches the life of what you already own. Our guide to making your clothes last longer picks up from there, and if water use is a broader concern around the house, our tips for saving water at home cover the rest.

Reader questions

Does washing in cold water really get clothes clean?

For most everyday stains and dirt, yes, especially with detergents formulated to work at temperatures as low as 60°F. Warm water still does a better job on stubborn odors, and pre-treating helps with heavy soiling.

Should I always run full loads?

One big load takes less energy than two smaller ones, but do not overpack. Clothes need room to move and hot air needs room to circulate, so use the small-load setting when you have only a few items.

Is a heat pump dryer worth considering?

Heat pump dryers use around 70 percent less energy than conventional models, so the payoff is largest for households that dry often and pay high electricity rates. Federal rebates of up to $840 may apply, but eligibility is managed by each state, territory and Tribe.

How often should I clean the lint filter?

After every load, since lint blocks airflow and makes the dryer run longer. Periodically check the outside vent too, to make sure it is clean and the flap closes properly when the dryer is off.

This article is general information, not financial, legal or tax advice. Programs, incentives and rules change, so check current details with official sources and qualified professionals before you decide.